The short version of epithalamin fits in a sentence. The long version — which is the one that helps — is below.
Reviewed 2025-10-12. Anything still debated is marked as such rather than presented as settled.
Epitalon is a synthetic four-amino-acid peptide with the sequence alanine-glutamate-aspartate-glycine, commonly abbreviated AEDG. Its molecular formula is C14H22N4O9, and its calculated molar mass is approximately 390.35 grams per mole. The compound is a short fragment related to a peptide fraction isolated from bovine pineal gland extracts, and it is normally supplied as a lyophilised powder intended for laboratory research. It is not a registered pharmaceutical product in most countries.
The peptide emerged from research carried out in Saint Petersburg from the late 1980s onward, where investigators searched for shorter active fragments of a pineal preparation known as epithalamin. The name epitalon was chosen to reflect that parent extract. Early reports described effects on neuroendocrine markers and on the lifespan of laboratory animals. Much of that work appeared in Russian-language journals, with English translations following later, which affects how readily the original protocols can be assessed by outside groups.
Published studies on epitalon are dominated by a small number of research groups, and independent replication in other laboratories remains limited. Proposed mechanisms include activation of telomerase and modulation of melatonin rhythms, but the evidence for either rests mainly on cell cultures and animal models. Whether the peptide produces comparable effects in humans is an open question, and the absence of large controlled trials means the literature is best read as exploratory rather than settled.
Verification of a sample usually begins with reversed-phase high-performance liquid chromatography, which resolves the peptide from truncated sequences and other impurities and expresses purity as a percentage of total peak area. Mass spectrometry by electrospray ionisation or matrix-assisted laser desorption supplies an independent check, because the measured mass can be compared against the theoretical value for AEDG. Amino acid analysis or tandem mass spectrometry sequencing can confirm residue order. Each of these methods answers a different question: a purity figure does not establish identity, and an identity match does not establish how much of the material is intact peptide.
The molecule is a short, linear, hydrophilic peptide that dissolves readily in water or aqueous buffer. Its principal chemical liabilities are hydrolytic rather than oxidative, since it contains no cysteine, methionine, or tryptophan residues. The aspartate–glycine step is a recognised site for aspartimide formation under mildly acidic or basic conditions, generating isoaspartate and succinimide-related products over time. Desiccated lyophilised powder held at −20 °C is comparatively stable, whereas dilute solutions degrade faster and are best frozen as single-use aliquots rather than thawed repeatedly.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C14H22N4O9 | Derived from the four-residue sequence |
| Molar mass | About 390.35 g/mol | Free peptide, counter-ion not included |
| Appearance | White to off-white powder | Lyophilised solid from aqueous solution |
| Water solubility | Freely soluble | Short, polar peptide chain |
| Common synonyms | AEDG; epithalone | Catalogues use the names interchangeably |
Interest in epitalon is usually discussed within the broader field of short peptide bioregulators, a category that includes other synthetic di-, tri-, and tetrapeptides studied by the same research group. These compounds share a common rationale: that small fragments of tissue-derived proteins can retain biological activity and can be produced reproducibly. The category as a whole remains outside mainstream pharmacological consensus, and epitalon specifically has a limited presence in independent, non-Russian research literature, which shapes how its evidence base is described.
Epitalon is a synthetic tetrapeptide with the amino acid sequence alanine-glutamate-aspartate-glycine, abbreviated Ala-Glu-Asp-Gly or AEDG. It was developed by the Russian researcher Vladimir Khavinson and colleagues during work on peptide bioregulators derived from the pineal gland. The compound is short enough to be produced by standard solid-phase peptide synthesis and is typically handled as a lyophilized white powder. Its small size distinguishes it from larger pineal peptides such as epithalamin, a complex extract from which the tetrapeptide was conceptually derived.
Solubility is high in water, phosphate-buffered saline and normal saline, a pattern that follows from the two acidic residues in the chain. The peptide dissolves poorly in non-polar solvents such as hexane or chloroform. Stock solutions are often prepared in water first and then diluted into the buffer of interest. Because the molecule is small and hydrophilic, filtration through a low-protein-binding membrane is usually straightforward, and visible particulates are uncommon in freshly made solutions.
Identity and purity are established with reversed-phase high-performance liquid chromatography and mass spectrometry. The chromatogram shows the main peak and any truncated or oxidised by-products, while the mass spectrum confirms the expected 390 dalton mass. Amino acid analysis can corroborate composition when a sample's origin is uncertain. Counterion content, particularly residual trifluoroacetate from purification, is frequently reported alongside purity because it shifts the net mass of the solid.
Epitalon is a synthetic tetrapeptide with the sequence alanine-glutamate-aspartate-glycine, abbreviated AEDG. Its molecular formula is C14H22N4O9 and its calculated monoisotopic mass is approximately 390.35 daltons. The compound does not occur naturally as a free peptide; it is produced by solid-phase peptide synthesis. Because it contains two acidic residues and no basic residues, the neutral form carries a net negative charge at physiological pH. This charge profile influences how the peptide behaves in solution and during chromatographic analysis.
Laboratory-grade epitalon is typically supplied as a lyophilized powder. Purity is commonly assessed with reverse-phase high-performance liquid chromatography, often paired with mass spectrometry to confirm molecular identity. Amino acid analysis and peptide mapping can provide additional confirmation of sequence. Certificates of analysis for research materials frequently report purity above 95 percent, although the methods behind such figures vary between suppliers. The absence of a pharmacopeial monograph means that no single standardized assay defines the compound, so reported results depend on the analytical protocol chosen.
Storage recommendations center on limiting moisture, heat, and light. The dry powder is generally kept at minus 20 degrees Celsius, and some suppliers recommend minus 80 degrees for long-term archival. Once dissolved, solutions are usually aliquoted and frozen to avoid repeated freeze-thaw cycles, which can promote aggregation or degradation. Aqueous stability depends on pH and concentration, and buffered saline is often preferred over plain water for biological work. Stability data specific to epitalon remain limited, so general peptide-handling practices are applied by analogy rather than from product-specific validation.
== Future directions == Data Loggers are changing more rapidly now than ever before. The original model of a stand-alone data logger is changed to one of a device that collects data but also has access to wireless communications for alarming of events, automatic reporting of data, and remote control. Data loggers are beginning to serve web pages for current readings, e-mail their alarms, and FTP their daily results into databases or direct to the users. Very recently, there is a trend to move away from proprietary products with commercial software to open-source software and hardware devices. The Raspberry Pi single-board computer is among others a popular platform hosting real-time Linux or preemptive-kernel Linux operating systems with many
=== Wet === Wet or canned dog food usually is packaged in a solid or soft-sided container. Wet food contains roughly 60–78% water, which is significantly higher in moisture than dry or semi-moist food. Canned food is commercially sterile (cooked during canning); other wet foods may not be sterile. Sterilizing is done through the process of retorting, which involves steam sterilization at 121 degrees Celsius. A given wet food will often be higher in protein or fat compared to a similar dry food on a dry matter basis (a measure which ignores moisture); given the canned food's high moisture content. A larger amount of canned food must be fed in order to meet the dog's required needs. Grain gluten and other protein gels may be used in wet dog food to create artificial meaty chunks, which look like real meat. This food is usually used for old dogs or puppies.
=== Pharmacokinetics === N-Desalkylflurazepam has an elimination half-life of 47–150 hours (up to 200 hours in some healthy volunteers), with an average of ~71 hours. Peak blood concentrations of N-Desalkylflurazepam is reached at 10.2 h following a single 15 mg dose of Flurazepam, typically around ~10-20.4 ng/mL. Its plasma levels are unreliable amongst patients, and are largely influenced by liver disease, liver enzyme inducers and inhibitors, as well as old age (in men).
Sources: en.wikipedia.org
Biological research in cold seeps and hydrothermal vents has been mostly focused on the microbiology and the prominent macro-invertebrates thriving on chemosynthetic microorganisms. Much less research has been done on the smaller benthic fraction at the size of the meiofauna (<1 mm). A community composition's orderly shift from one set of species to another is called ecological succession. The first type of organism to take advantage of this deep-sea energy source is bacteria. Aggregating into bacterial mats at cold seeps, these bacteria metabolize methane and hydrogen sulfide (another gas that emerges from seeps) for energy. This process of obtaining energy from chemicals is known as chemosynthesis.
==== Unintended use ==== It is not safe to calculate divided doses by cutting and weighing medical skin patches, because there's no guarantee that the substance is evenly distributed on the patch surface. For example, fentanyl transdermal patches are designed to slowly release the substance over 3 days. It is well known that cut fentanyl transdermal consumed orally have cause overdoses and deaths. Single blotting papers for illicit drugs injected from solvents in syringes may also cause uneven distribution across the surface.
x = number of abnormal spermatozoa. h = number of spermatozoa with head abnormalities. m = number of spermatozoa with midpiece abnormalities. t = number of spermatozoa with tail abnormalities. Another interesting index is the sperm deformity index (SDI), which is calculated the same way as the TZI, but instead of dividing by the number of abnormal spermatozoa, the division is by the total number of spermatozoa counted. The TZI takes values from 1 (only one abnormality per sperm) to 3 (each sperm has the three types of abnormalities). Morphology is a predictor of success in fertilizing oocytes during in vitro fertilization. Up to 10% of all spermatozoa have observable defects and as such are disadvantaged in terms of fertilising an oocyte. Also, sperm cells with tail-tip swelling patterns generally have lower frequency of aneuploidy.
Sources: en.wikipedia.org
It is a synthetic tetrapeptide built from alanine, glutamate, aspartate and glycine. The four residues are joined by standard peptide bonds, giving a linear chain rather than a branched structure.
The name derives from epithalamin, a pineal gland extract studied in the former Soviet Union. Researchers proposed that short fragments of that extract carried the biological activity of interest.
No major regulatory agency has approved it as a medicine. It is handled as a research chemical, and products sold under this name are not standardised drugs with defined clinical labelling.
Mass spectrometry provides the identity check, because the observed mass is compared with the theoretical mass of the AEDG sequence. Chromatography separates and quantifies impurities but does not by itself prove which peptide is present. The two techniques are normally used together.