Epitalon Peptide Background And Structure — Reference Sheet

By Editorial Desk · published 2025-09-04 · last reviewed 2025-10-04 · Topic

A practical reference on epithalamin: what it is, how it behaves, what the literature reports, and where the honest uncertainties sit.

This page was last updated on 2025-10-04 and is reviewed periodically as new material appears.

Epitalon Peptide Background and Structure

Epitalon is a synthetic tetrapeptide with the amino acid sequence alanine-glutamate-aspartate-glycine, abbreviated Ala-Glu-Asp-Gly or AEDG. It was developed by the Russian researcher Vladimir Khavinson and colleagues during work on peptide bioregulators derived from the pineal gland. The compound is short enough to be produced by standard solid-phase peptide synthesis and is typically handled as a lyophilized white powder. Its small size distinguishes it from larger pineal peptides such as epithalamin, a complex extract from which the tetrapeptide was conceptually derived.

The four residues give epitalon a molecular formula of C14H22N4O9 and a molecular weight near 390.35 daltons. The presence of two acidic residues, glutamate and aspartate, makes the free peptide strongly acidic, while the alanine and glycine ends provide neutral, nonpolar character. This combination produces a molecule with substantial water solubility. Because there are no cysteine, methionine, or tryptophan residues, the peptide lacks the most common oxidation-sensitive side chains, which simplifies handling compared with many longer peptides.

Analytical Methods and Storage

Identity and purity of epitalon samples are normally established by reversed-phase high-performance liquid chromatography with ultraviolet detection near 214 nanometres, combined with mass spectrometry. The mass spectrum confirms the expected molecular ion and can reveal truncated or oxidised by-products. Amino acid analysis after acid hydrolysis verifies that the four residues are present in the expected ratio. Certificates typically report a purity figure taken from chromatographic peak area, expressed as a percentage of total integrated signal.

Lyophilised epitalon is generally held at minus twenty degrees Celsius in a sealed container kept dry and dark. Cooler conditions are sometimes recommended for long-term archives. The solid takes up moisture readily enough that repeated opening of a vial introduces water, so dividing a batch into smaller portions before storage lowers degradation risk. Aqueous solutions are less durable than the dry powder and are usually prepared shortly before use, then kept cold and shielded from light to slow hydrolysis and oxidation.

Epitalon at a glance

Structure, Naming and Discovery

Epitalon is a synthetic tetrapeptide whose four residues are alanine, glutamate, aspartate and glycine, commonly abbreviated AEDG. Its molecular formula is C14H22N4O9 and its monoisotopic mass is near 390.35 daltons. The peptide carries two acidic side chains, so it is neutral to negatively charged in most aqueous buffers. Published reference summaries usually list it under both spellings, epitalon and epithalon, and treat the two names as the same material.

The compound is generally described as a synthetic analogue of a fragment isolated from a pineal gland extract. Researchers associated with the Saint Petersburg Institute of Bioregulation and Gerontology introduced it during the 1980s and 1990s while studying short peptides from animal tissue. The original extract, called epithalamin, is a heterogeneous mixture, whereas epitalon is a single defined sequence. That distinction matters because findings reported for the extract are not automatically findings about the pure tetrapeptide, and claims about broader biological effects remain a separate question from the chemical identity described here.

Related pages on this site

• Professional report
• Practical dataset
• Focused checklist
• Connected archive
• Quality handbook
• Standard digest
• Scalable reference
• Durable review

Analytical Verification and Storage

Verification of a sample usually begins with reversed-phase high-performance liquid chromatography, which resolves the peptide from truncated sequences and other impurities and expresses purity as a percentage of total peak area. Mass spectrometry by electrospray ionisation or matrix-assisted laser desorption supplies an independent check, because the measured mass can be compared against the theoretical value for AEDG. Amino acid analysis or tandem mass spectrometry sequencing can confirm residue order. Each of these methods answers a different question: a purity figure does not establish identity, and an identity match does not establish how much of the material is intact peptide.

The molecule is a short, linear, hydrophilic peptide that dissolves readily in water or aqueous buffer. Its principal chemical liabilities are hydrolytic rather than oxidative, since it contains no cysteine, methionine, or tryptophan residues. The aspartate–glycine step is a recognised site for aspartimide formation under mildly acidic or basic conditions, generating isoaspartate and succinimide-related products over time. Desiccated lyophilised powder held at −20 °C is comparatively stable, whereas dilute solutions degrade faster and are best frozen as single-use aliquots rather than thawed repeatedly.

Background from the literature

RCO2H + R'OH ⇌ RCO2R' + H2O The equilibrium constant for such reactions is about 5 for typical esters, e.g., ethyl acetate. The reaction is slow in the absence of a catalyst. Sulfuric acid is a typical catalyst for this reaction. Many other acids are also used such as polymeric sulfonic acids. Since esterification is highly reversible, the yield of the ester can be improved using Le Chatelier's principle:

=== Benzodiazepines === Benzodiazepines are used for acute anxiety and could be added along with current use of SSRIs to stabilize a treatment. Long-term use in treatment plans is not recommended. Different kinds of benzodiazepine will vary in its pharmacological profile, including its strength of effect and time taken for metabolism. The choice of the benzodiazepine will depend on the corresponding profiles. Benzodiazepines are used for emergent or short-term management. They are not recommended as the first-line anti-anxiety drugs, but they can be used in combination with SSRIs/SNRIs during the initial treatment stage. Indications include panic disorder, sleep disorders, seizures, acute behavioral disturbance, muscle spasm and premedication and sedation for procedures.

Daptomycin, sold under the brand name Cubicin among others, is a lipopeptide antibiotic used in the treatment of systemic and life-threatening infections caused by Gram-positive organisms. Daptomycin was removed from the World Health Organization's List of Essential Medicines in 2019. The World Health Organization classifies daptomycin as critically important for human medicine.

Sources: en.wikipedia.org

Reference notes

In funeral services, the body is often put on display. Many cultures feel that the deceased should be presented looking their finest. Others dress the deceased in burial shrouds, which range from very simple to elaborate depending on the culture. The inclusion of ceremonial garb and sacred objects is sometimes viewed as necessary for reaching the afterlife. The inclusion of personal effects may be motivated by the beliefs that in the afterlife people will wish to have with them what was important to them on earth. Alternatively, in some cultures, it is felt that, when a person dies, their possessions (and sometimes people connected to them such as wives) should go with them out of loyalty or ownership. Although not generally a motivation for the inclusion of grave goods with a corpse, it is worth considering that future archaeologists may find the remains (compare time capsule). Artifacts such as clothing and objects provide insight into how the individual lived. This provides a form of immortality for the deceased. In general, however, clothing buried with a body decays more rapidly than the same buried alone.

It contains a syringe-like reservoir with about three days' insulin supply. This is connected by thin, disposable, plastic tubing to a needle-like cannula inserted into the patient's skin and held in place by an adhesive patch. The infusion tubing and cannula must be removed and replaced every few days. An insulin pump can be programmed to infuse a steady amount of rapid-acting insulin under the skin. This steady infusion is termed the basal rate and is designed to supply the background insulin needs. Each time the patient eats, he or she must press a button on the pump to deliver a specified dose of insulin to cover that meal. Extra insulin is also given the same way to correct a high glucose reading. Although current pumps can include a glucose sensor, they cannot automatically respond to meals or to rising or falling glucose levels. Both MDI and pumping can achieve similarly excellent glycemic control. Some people prefer injections because they are less expensive than pumps and do not require the wearing of a continually attached device. However, the clinical literature is very clear that patients whose basal insulin requirements tend not to vary throughout the day or do not require dosage precision smaller than 0.5 IU, are much less likely to realize much significant advantage of pump therapy. Another perceived advantage of pumps is the freedom from syringes and injections, however, infusion sets still require less frequent injections to guide infusion sets into the subcutaneous tissue. Intensive/flexible insulin therapy requires frequent blood glucose checking.

Angiotensin II also acts on the smooth muscle in the walls of the arterioles causing these small diameter vessels to constrict, thereby restricting the outflow of blood from the arterial tree, causing the arterial blood pressure to rise. This, therefore, reinforces the measures described above (under the heading of "Arterial blood pressure"), which defend the arterial blood pressure against changes, especially hypotension. The angiotensin II-stimulated aldosterone released from the zona glomerulosa of the adrenal glands has an effect on particularly the epithelial cells of the distal convoluted tubules and collecting ducts of the kidneys. Here it causes the reabsorption of sodium ions from the renal tubular fluid, in exchange for potassium ions which are secreted from the blood plasma into the tubular fluid to exit the body via the urine. The reabsorption of sodium ions from the renal tubular fluid halts further sodium ion losses from the body, and therefore preventing the worsening of hyponatremia. The hyponatremia can only be corrected by the consumption of salt in the diet. However, it is not certain whether a "salt hunger" can be initiated by hyponatremia, or by what mechanism this might come about. When the plasma sodium ion concentration is higher than normal (hypernatremia), the release of renin from the juxtaglomerular apparatus is halted, ceasing the production of angiotensin II, and its consequent aldosterone-release into the blood. The kidneys respond by excreting sodium ions into the urine, thereby normalizing the plasma sodium ion concentration.

Sources: en.wikipedia.org

Reference notes

The Gibbs phase rule states that, under most thermodynamic conditions (fixed temperature, pressure, chemical potential, and other intensive thermodynamic properties), for each chemical species, only one phase is thermodynamically stable (i.e. have the lowest Gibbs free energy per volume), except on certain boundaries, such as the coexistence of ice and water right at the freezing point. In particular, since each crystal morph is a phase of matter, this implies that under normal circumstances, there exists only a single crystal morph at thermodynamic equilibrium. However, some phases may be kinetically stable, even if not energetically so. Disappearing polymorphs occur when there are two morphs of a substance, and one morph has lower Gibbs free energy, but is kinetically slower to form. Thus, when the crystal is first formed, the kinetically faster morph occurs first. Eventually, by accident or catalysis, the other morph occurs, which can then serve as seed crystal. More abstractly stated, disappearing polymorphs are morphs that are kinetically stable but not thermodynamically stable.

=== Orthogonal system === The possibility has been proposed and studied, both theoretically and experimentally, of implementing an orthogonal system inside cells independent of the cellular genetic material in order to make a completely safe system, with the possible increase in encoding potentials. Several groups have focused on different aspects:

Bats are the only mammals that can truly fly. They fly through the air at a constant speed by moving their wings up and down (usually with some fore-aft movement as well). Because the animal is in motion, there is some airflow relative to its body which, combined with the velocity of the wings, generates a faster airflow moving over the wing. This generates a lift force vector pointing forwards and upwards, and a drag force vector pointing rearwards and upwards. The upwards components of these counteract gravity, keeping the body in the air, while the forward component provides thrust to counteract both the drag from the wing and from the body as a whole. The wings of bats are much thinner and consist of more bones than those of birds, allowing bats to maneuvere more accurately and fly with more lift and less drag. By folding the wings inwards towards their body on the upstroke, they use 35% less energy during flight than birds. The membranes are delicate, ripping easily; however, the tissue of the bat's membrane is able to regrow, such that small tears can heal quickly. The surface of their wings is equipped with touch-sensitive receptors on small bumps called Merkel cells, also found on human fingertips. These sensitive areas are different in bats, as each bump has a tiny hair in the center, making it even more sensitive and allowing the bat to detect and collect information about the air flowing over its wings, and to fly more efficiently by changing the shape of its wings in response.

Sources: en.wikipedia.org

Frequently asked questions