A practical reference on Reversed-phase HPLC: what it is, how it behaves, what the literature reports, and where the honest uncertainties sit.
Reviewed 2026-05-07. Anything still debated is marked as such rather than presented as settled.
Laboratory-grade epitalon is typically supplied as a lyophilized powder. Purity is commonly assessed with reverse-phase high-performance liquid chromatography, often paired with mass spectrometry to confirm molecular identity. Amino acid analysis and peptide mapping can provide additional confirmation of sequence. Certificates of analysis for research materials frequently report purity above 95 percent, although the methods behind such figures vary between suppliers. The absence of a pharmacopeial monograph means that no single standardized assay defines the compound, so reported results depend on the analytical protocol chosen.
Storage recommendations center on limiting moisture, heat, and light. The dry powder is generally kept at minus 20 degrees Celsius, and some suppliers recommend minus 80 degrees for long-term archival. Once dissolved, solutions are usually aliquoted and frozen to avoid repeated freeze-thaw cycles, which can promote aggregation or degradation. Aqueous stability depends on pH and concentration, and buffered saline is often preferred over plain water for biological work. Stability data specific to epitalon remain limited, so general peptide-handling practices are applied by analogy rather than from product-specific validation.
Epitalon is a synthetic tetrapeptide with the sequence alanine-glutamate-aspartate-glycine, abbreviated AEDG. Its molecular formula is C14H22N4O9 and its calculated monoisotopic mass is approximately 390.35 daltons. The compound does not occur naturally as a free peptide; it is produced by solid-phase peptide synthesis. Because it contains two acidic residues and no basic residues, the neutral form carries a net negative charge at physiological pH. This charge profile influences how the peptide behaves in solution and during chromatographic analysis.
Identity testing for epitalon relies on reversed-phase high-performance liquid chromatography for purity and mass spectrometry for mass confirmation. Because the sequence contains no tryptophan or tyrosine, ultraviolet detection at 280 nanometres is insensitive, so chromatographic methods usually monitor absorbance near 214 nanometres, where the peptide backbone absorbs. Electrospray ionisation or matrix-assisted laser desorption/ionisation then checks the intact mass against the expected value near 390 daltons. Peptide mapping or amino acid analysis after acid hydrolysis can supplement these measurements, although such confirmatory work is seldom reported on commercial certificates of analysis.
Stability of the tetrapeptide follows ordinary peptide chemistry rather than any unusual structural feature. The aspartate-glycine pair is prone to aspartimide formation under mildly basic or neutral conditions, and deamidation can follow, altering both mass and chromatographic retention. Dry lyophilised powder kept at or below minus twenty degrees Celsius is the usual handling recommendation, with repeated freeze-thaw cycles avoided. Once dissolved in neutral aqueous buffer, degradation proceeds over days to weeks depending on pH and temperature, while acidic conditions generally slow the aspartimide route. A formal stability-indicating study has not been published in the indexed literature.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C14H22N4O9 | Free acid form of the tetrapeptide |
| Molecular mass | About 390.35 Da | Calculated monoisotopic value |
| Appearance | White to off-white powder | Typical lyophilized presentation |
| Solubility | Soluble in water | Also dissolves in buffered saline |
| Storage temperature | Minus 20 degrees Celsius | Dry, dark conditions; avoid repeated thawing |
Epitalon is the common name for a synthetic tetrapeptide with the sequence alanine-glutamate-aspartate-glycine, usually abbreviated AEDG. All four residues are proteinogenic amino acids, and the free peptide has a calculated mass near 390 grams per mole. Because the chain is short and carries no modifications, it is assembled readily by solid-phase synthesis and is distributed mainly as a freeze-dried solid for laboratory work. Catalogue listings use the spellings epitalon, epithalone, and simply AEDG, and the three refer to the same sequence.
The compound is generally presented as a synthetic fragment of epithalamin, a pineal gland extract investigated in the former Soviet Union from the 1970s onward. Vladimir Khavinson and colleagues in Saint Petersburg developed short peptides modelled on such extracts, and epitalon became the most widely cited of those sequences. Most primary reports appeared in Russian-language journals or in proceedings with limited international circulation. Independent replication in laboratories outside that network remains sparse, and much repeated secondary material traces back to a small number of originating groups.
Laboratory work has examined effects on telomerase activity in cultured cells, on melatonin rhythms in animals, and on markers of oxidative stress. Some experiments report measurable changes while others show none, and the reported findings rest largely on small studies. The absence of large independent trials means the generality of these results is unresolved rather than settled. Review articles occasionally apply the label geroprotector, a term that reflects a research hypothesis about ageing rather than an established clinical finding.
The molecule is a short, linear, hydrophilic peptide that dissolves readily in water or aqueous buffer. Its principal chemical liabilities are hydrolytic rather than oxidative, since it contains no cysteine, methionine, or tryptophan residues. The aspartate–glycine step is a recognised site for aspartimide formation under mildly acidic or basic conditions, generating isoaspartate and succinimide-related products over time. Desiccated lyophilised powder held at −20 °C is comparatively stable, whereas dilute solutions degrade faster and are best frozen as single-use aliquots rather than thawed repeatedly.
No pharmacopoeial monograph exists for this peptide, so quality rests on the supplier's internal specifications and on whatever independent testing a purchaser arranges. Certificates of analysis differ widely in which tests they report and in the limits applied. The counter-ion introduced during purification, commonly acetate or trifluoroacetate, changes the net peptide content of a given mass of powder, so two samples of equal weight may not contain equal amounts of the active sequence. Third-party laboratories can verify purity, identity, residual solvents, and counter-ion content for a fee, which makes documentation more informative than labelling.
Material supplied for laboratory use is normally a lyophilised white to off-white powder that dissolves readily in water and in isotonic saline. Lyophilised cakes are hygroscopic and should be equilibrated to room temperature before opening to limit condensation on the solid. Solutions are typically prepared at milligram-per-millilitre concentrations and divided into single-use aliquots, because repeated freeze–thaw cycles degrade short peptides. Aqueous solutions are far less stable than the dry powder, and identity is usually verified by mass spectrometry alongside purity estimation from reversed-phase high-performance liquid chromatography.
Epitalon is a synthetic linear tetrapeptide with the sequence alanine–glutamate–aspartate–glycine, abbreviated AEDG. Its molecular formula is C14H22N4O9 and the calculated mass is approximately 390.35 g/mol. The compound is made by solid-phase peptide synthesis rather than extracted from tissue, although early work described it as a short fragment of a peptide fraction obtained from bovine pineal extract. In the research literature the spelling epitalon and the variant epithalone both appear, while AEDG is the standard code used in peptide nomenclature.
Several names circulate for the same molecule, including epitalon, epithalone, epithalamin tetrapeptide, and the sequence code AEDG. A CAS registry number, 307297-39-8, is commonly cited for it, though catalogue entries should be checked against supplier documentation because mislabelled records occur. In its usual form the peptide carries free amino and carboxyl termini and is neither glycosylated nor lipidated. Researchers distinguish the defined tetrapeptide from epithalamin itself, a crude pineal preparation containing many peptides that is not chemically characterised.
Lyophilised epitalon is generally held at minus twenty degrees Celsius in a sealed container kept dry and dark. Cooler conditions are sometimes recommended for long-term archives. The solid takes up moisture readily enough that repeated opening of a vial introduces water, so dividing a batch into smaller portions before storage lowers degradation risk. Aqueous solutions are less durable than the dry powder and are usually prepared shortly before use, then kept cold and shielded from light to slow hydrolysis and oxidation.
Verification of research-grade material involves comparing a supplier chromatogram against an in-house reference, checking the observed mass against the calculated value, and where possible confirming residue order by tandem mass spectrometry or enzymatic peptide mapping. Purity claims should be read alongside the method used to obtain them, because detection wavelength and integration settings alter the result. Batch-specific data, rather than a generic grade statement, is the informative part of a certificate.
An alternative latex method sometimes used in China in the past is to cut off the poppy heads, run a large needle through them, and collect the dried latex 24 to 48 hours later. In India, opium harvested by licensed poppy farmers is dehydrated to uniform levels of hydration at government processing centers and then sold to pharmaceutical companies that extract morphine from the opium. However, in Turkey and Tasmania, morphine is obtained by harvesting and processing the fully mature dry seed pods with attached stalks, called poppy straw. In Turkey, a water extraction process is used, while in Tasmania, a solvent extraction process is used. Opium poppy contains at least 50 different alkaloids, but most of them are of low concentration. Morphine is the principal alkaloid in raw opium and constitutes roughly 8–19% of opium by dry weight (depending on growing conditions). Some purpose-developed strains of poppy now produce opium that is up to 26% morphine by weight. A rough rule of thumb to determine the morphine content of pulverised dried poppy straw is to divide the percentage expected for the strain or crop via the latex method by eight or an empirically determined factor, which is often in the range of 5 to 15. The Norman strain of P. somniferum, also developed in Tasmania, produces as little as 0.04% morphine but with much higher amounts of thebaine and oripavine, which can be used to synthesise semi-synthetic opioids as well as other drugs like stimulants, emetics, opioid antagonists, anticholinergics, and smooth-muscle agents.
=== Cancer === Depending on the type of cancer presented and the context, galectin-7 can either be helpful to suppress cancer or promote the cancer. What is suppressive of one tissue, such as the stomach, may be promotive in another, such as breast cancer or in the oral epithelium. It can up regulate by p53, making it a part of the pro-apoptotic network, however this can still be part of a promoter of tumors if apoptosis goes unregulated. P53 status is noted in cancers because of the chance for a mutant p53 where the balance of apoptosis processes could shift to metastasis. In some cancers, the protein enhances apoptosis through mitochondrial pathways, and disruption of survival signaling. There have been observations to suggest a correlation between tumor progression and human lumphoid disease as well because of an accumulation of galectin-7 with no expression detected in normal tissue where it is normally found. Galectin-7 has been mainly studies under carcinoma cancers and have shown how they are associated with a decrease in galectin-7 expression however, squamous epithelial and mucous tumors still express higher galectin-7 levels than normal tissues in cancers having to do with the head and neck. This displays how over expression and under expression of galectin-7 can be cause for concern when it comes to developing cancers in the body. The protein has also been found to down regulate, meaning the tumor cells have a reduced expression of galectin-7, producing an association, not necessarily causation, to poor tumor differentiation.
=== Border fortification === In a report published in November 2022, the NGO Human Rights Watch found a marked increase in border fortification in a 7.4 kilometres (4.6 mi) long section of the border around Hoeryong. A HRW staff said that the COVID-19 pandemic had been a pretext in building new fences, guard posts and other infrastructure. Fortifications along wider stretches of the border were reported by Reuters in May 2023.
Sources: en.wikipedia.org
== V == Van Leusen reaction Van Slyke determination Varrentrapp reaction Vilsmeier reaction Vilsmeier–Haack reaction Voight amination Volhard–Erdmann cyclization von Braun amide degradation von Braun reaction von Richter cinnoline synthesis von Richter reaction
Other protein assay like BCA and Lowry are ineffective because molecules like reducing agents interfere with the assay. Using Bradford can be advantageous against these molecules because they are compatible to each other and will not interfere. The linear graph acquired from the assay (absorbance versus protein concentration in μg/mL) can be easily extrapolated to determine the concentration of proteins by using the slope of the line. It is a sensitive technique. It is also very simple: measuring the OD at 595 nm after 5 minutes of incubation. This method can also make use of a Vis spectrophotometer or a mobile smartphone camera (RGBradford method).
=== Serotonin syndrome === The development of a potentially life-threatening serotonin syndrome (also classified as "serotonin toxicity") may occur with venlafaxine treatment, particularly with concomitant use of serotonergic drugs, including but not limited to SSRIs and SNRIs, many hallucinogens such as tryptamines and phenethylamines (e.g., LSD/LSA, DMT, MDMA, mescaline), dextromethorphan (DXM), tramadol, tapentadol, pethidine (meperidine) and triptans and with drugs that impair metabolism of serotonin (including MAOIs). Serotonin syndrome symptoms may include mental status changes (e.g. agitation, hallucinations, coma), autonomic instability (e.g. tachycardia, labile blood pressure, hyperthermia), neuromuscular aberrations (e.g. hyperreflexia, incoordination), or gastrointestinal symptoms (e.g. nausea, vomiting, diarrhea). Venlafaxine-induced serotonin syndrome has also been reported when venlafaxine has been taken in isolation in overdose. An abortive serotonin syndrome state, in which some but not all of the symptoms of the full serotonin syndrome are present, has been reported with venlafaxine at mid-range dosages (150 mg per day). A case of a patient with serotonin syndrome induced by low-dose venlafaxine (37.5 mg per day) has also been reported.
Sources: en.wikipedia.org
Epitalon is a synthetic tetrapeptide built from four amino acids: alanine, glutamate, aspartate, and glycine. It is not extracted from a natural source but made in the laboratory by chemical synthesis. Its short length makes it relatively straightforward to produce at high purity.
No naturally occurring free form of the peptide has been described. The four-amino-acid sequence can appear as a fragment within larger proteins, but that is not the same as the intact compound being present as a circulating molecule. Materials used in research are synthetic.
Purity is usually checked by reverse-phase high-performance liquid chromatography, which separates the target peptide from related impurities. Mass spectrometry is commonly used alongside it to confirm molecular mass. Some suppliers also provide amino acid analysis for additional sequence confirmation.
The molecule lacks aromatic residues, so it absorbs weakly near 280 nanometres, the wavelength applied to many other peptides. The peptide bond absorbs strongly below 220 nanometres, making 214 nanometres a practical compromise. Gradient methods must therefore use mobile phases with low ultraviolet absorbance to keep the baseline clean.