Deamidation is one of those subjects where the details matter more than the headlines. This page pulls together the background, the mechanisms, and the practical points readers ask about most.
Updated 2026-04-26. Numbers and descriptions here follow the published literature rather than marketing material.
Storage practice centres on limiting moisture, oxygen, and repeated temperature cycling. Freeze-dried powder is generally held desiccated at minus twenty degrees Celsius or colder and protected from light. Reconstituted solutions are markedly less stable, and the aspartate-glycine junction is prone to succinimide formation at neutral to mildly alkaline pH. Portioning material into single-use aliquots reduces degradation compared with repeated freeze-thaw cycles. Stability data specific to this tetrapeptide remain scarce, so most handling guidance is extrapolated from general peptide chemistry rather than measured directly.
Documentation accompanying research peptides usually includes a certificate of analysis listing the batch number, purity figure, and test methods applied. Buyers comparing suppliers should check whether the reported purity refers to chromatographic area or to a mass-balance calculation, because the two are not equivalent. Counter-ion content, residual solvents, and water content are sometimes omitted from such certificates even though they affect the actual peptide mass present. Independent verification through a second laboratory is the most direct way to confirm that a supplied material matches its label.
Purity assessment of peptide reagents normally relies on reversed-phase high-performance liquid chromatography. A gradient of acetonitrile in water with trifluoroacetic acid, paired with a C18 stationary phase, separates the target tetrapeptide from truncated sequences and deletion analogues. Detection at 214 nanometres exploits absorbance of the peptide backbone, since the molecule contains no aromatic residue. Results are expressed as a percentage of total peak area. Values above ninety-five percent are typical for research-grade material, although reporting conventions vary between suppliers.
In its supplied form epitalon is a white to off-white powder, usually lyophilized and often hygroscopic. It dissolves readily in water and in aqueous buffers, and it is commonly handled as the acetate or trifluoroacetate salt to improve stability during purification and drying. The amide backbone is labile in aqueous media, so solutions are less durable than the dry solid. Handling notes in the chemical literature therefore emphasize keeping the powder dry, cool and shielded from light until it is dissolved.
Epitalon is a synthetic tetrapeptide whose sequence is alanine-glutamate-aspartate-glycine, written in single-letter code as AEDG. The four residues are joined by three peptide bonds, giving a linear backbone with no branching and no disulfide bridges. Its calculated molecular mass for the free form is approximately 390.3 daltons, a figure that rises when the compound is supplied as an acetate or trifluoroacetate salt. Because the chain is short, the molecule is defined entirely by its residue order rather than by any folded three-dimensional structure.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white powder | Freeze-dried solid |
| Solubility class | Freely soluble in water | Aqueous buffers also suitable |
| Typical storage temperature | Minus 20 degrees Celsius or colder | Desiccated and light protected |
| Typical analytical method | RP-HPLC with UV detection | 214 nm on C18 column |
| Identity confirmation | Electrospray mass spectrometry | Sequence verified separately |
Regulatory treatment differs by country. No formulation of epitalon holds a marketing authorisation as a medicine in the United States or the European Union, where material sold for laboratory use is handled as a research chemical and is not intended for human consumption. In Russia, several short peptide preparations from the same institute's peptide series are registered medicinal products, and epitalon appears in that national context. Elsewhere it is frequently offered as a cosmetic ingredient, a category with lighter requirements. Advertising claims about longevity or disease prevention are restricted in most jurisdictions, which limits how sellers describe the compound.
Freeze-dried epitalon is normally kept at minus twenty degrees Celsius in a sealed, desiccated container, protected from light. Short excursions at ambient temperature during shipping are generally tolerated, but repeated warming and cooling cycles encourage moisture uptake, which shortens shelf life. Once dissolved, the peptide is far less stable than the solid: aqueous solutions are subject to hydrolysis and to deamidation at the aspartate and glutamate residues. Working solutions are therefore held refrigerated and used within days, and repeated freezing and thawing of the same vial is best avoided.
Residue composition is the property that most cleanly separates verified material from mislabelled samples. Alanine, glutamate, aspartate and glycine appear in that order from the N-terminus, and the two acidic residues sit in the middle of the chain. Because the peptide is short, it can be produced by solid-phase synthesis and characterised by mass spectrometry without ambiguity. Any reported sample whose measured mass departs substantially from 390 daltons is a different compound or a degraded mixture rather than epitalon.
Epitalon is a synthetic tetrapeptide whose four residues are alanine, glutamate, aspartate and glycine, commonly abbreviated AEDG. Its molecular formula is C14H22N4O9 and its monoisotopic mass is near 390.35 daltons. The peptide carries two acidic side chains, so it is neutral to negatively charged in most aqueous buffers. Published reference summaries usually list it under both spellings, epitalon and epithalon, and treat the two names as the same material.
The compound is generally described as a synthetic analogue of a fragment isolated from a pineal gland extract. Researchers associated with the Saint Petersburg Institute of Bioregulation and Gerontology introduced it during the 1980s and 1990s while studying short peptides from animal tissue. The original extract, called epithalamin, is a heterogeneous mixture, whereas epitalon is a single defined sequence. That distinction matters because findings reported for the extract are not automatically findings about the pure tetrapeptide, and claims about broader biological effects remain a separate question from the chemical identity described here.
Because epitalon has no pharmacopoeial monograph, quality assessment depends on supplier documentation and independent testing. Certificates of analysis typically report a purity figure from a single chromatographic run, a measured mass and sometimes an appearance description, but methods and acceptance criteria are not harmonised across vendors. Third-party laboratories can repeat identity and purity measurements, and mismatches between labelled and measured peptide content have been described for research peptides generally. What constitutes adequate identity confirmation for a molecule of this size stays an open question, since mass agreement alone does not separate closely related sequences.
Identity testing for epitalon relies on reversed-phase high-performance liquid chromatography for purity and mass spectrometry for mass confirmation. Because the sequence contains no tryptophan or tyrosine, ultraviolet detection at 280 nanometres is insensitive, so chromatographic methods usually monitor absorbance near 214 nanometres, where the peptide backbone absorbs. Electrospray ionisation or matrix-assisted laser desorption/ionisation then checks the intact mass against the expected value near 390 daltons. Peptide mapping or amino acid analysis after acid hydrolysis can supplement these measurements, although such confirmatory work is seldom reported on commercial certificates of analysis.
Stability of the tetrapeptide follows ordinary peptide chemistry rather than any unusual structural feature. The aspartate-glycine pair is prone to aspartimide formation under mildly basic or neutral conditions, and deamidation can follow, altering both mass and chromatographic retention. Dry lyophilised powder kept at or below minus twenty degrees Celsius is the usual handling recommendation, with repeated freeze-thaw cycles avoided. Once dissolved in neutral aqueous buffer, degradation proceeds over days to weeks depending on pH and temperature, while acidic conditions generally slow the aspartimide route. A formal stability-indicating study has not been published in the indexed literature.
Published work on this compound consists mainly of in vitro experiments, animal studies, and small clinical investigations, a substantial share of which appeared in Russian-language journals. Sample sizes are generally small, control conditions differ between studies, and several endpoints rely on markers whose clinical meaning is itself debated. Reviews of the longevity field treat the peptide as an early example of telomerase-directed research rather than an established intervention. Regulatory treatment varies by country: some jurisdictions place it under prescription controls, others treat it as a laboratory material, and importation may be restricted regardless of local status.
Epitalon is a synthetic tetrapeptide whose sequence is alanine–glutamate–aspartate–glycine, commonly abbreviated AEDG. It was developed in Russia during the 1980s and 1990s by investigators associated with the St. Petersburg Institute of Bioregulation and Gerontology, who studied short peptides as regulators of gene expression and tissue function. The alternative spelling epithalon appears interchangeably in the literature, and the two names refer to the same molecule. Outside Russia it is encountered chiefly as a research chemical rather than a licensed medicine, and it holds no approval from the United States Food and Drug Administration or the European Medicines Agency.
The peptide is a synthetic analogue of epithalamin, a preparation extracted from bovine pineal glands. Investigators sought a short, chemically defined molecule that would reproduce some of the endocrine and gerontological observations attributed to the glandular extract. Proposed mechanisms centre on induction of telomerase activity, an effect reported in cultured human somatic cells in the early 2000s, together with influences on melatonin secretion and neuroendocrine regulation. Those mechanisms remain incompletely characterised, and the reported telomerase response has not been consistently reproduced by independent groups working in comparable systems.
== See also == Charcot–Marie–Tooth disease classifications Christina's World – 1948 painting by Andrew Wyeth Hereditary motor and sensory neuropathies Hereditary motor neuropathies Low copy repeats Palmoplantar keratoderma and spastic paraplegia
Biography at the Biographical Directory of the United States Congress Financial information (federal office) at the Federal Election Commission Legislation sponsored at the Library of Congress Profile at Vote Smart
=== Salinization/acidification of soils === Sediment from abandoned aquaculture farms can remain hypersaline, acidic and eroded. This material can remain unusable for aquaculture purposes for long periods thereafter. Various chemical treatments, such as adding lime, can aggravate the problem by modifying the physicochemical characteristics of the sediment.
There is currently insufficient evidence to recommend any medication for OSA. This may result in part because people with sleep apnea have tended to be treated as a single group in clinical trials. Identifying specific physiological factors underlying sleep apnea makes it possible to test drugs specific to those causal factors: airway narrowing, impaired muscle activity, low arousal threshold for waking, and unstable breathing control. Those who experience low waking thresholds may benefit from eszopiclone, a sedative typically used to treat insomnia. The antidepressant desipramine may stimulate upper airway muscles and lessen pharyngeal collapsibility in people who have limited muscle function in their airways. There is limited evidence for medication, but 2012 AASM guidelines suggested that acetazolamide "may be considered" for the treatment of central sleep apnea; zolpidem and triazolam may also be considered for the treatment of central sleep apnea, but "only if the patient does not have underlying risk factors for respiratory depression". Low doses of oxygen are also used as a treatment for hypoxia but are discouraged due to side effects. In December 2024, the FDA approved tirzepatide, an anti-diabetic and weight loss medication, as a component in the combination treatment of adults with obesity suffering from moderate to severe obstructive sleep apnea. Other components of the therapy are a reduced-calorie diet and increased physical activity.
== Design nanoparticle self-assembly structure == Self-assembly of nanoparticles is driven by either maximization of packing density or minimization of the contact area between particles according to hard or soft nanoparticles. Examples of hard nanoparticles are: silica, fullerenes; soft nanoparticles are often organic nanoparticles, block copolymer micelles, DNA nanoparticles. The ordered self-assembly structure of nanoparticles is called superlattice.
Sources: en.wikipedia.org
== External links == Adrenocorticotropic+Hormone at the U.S. National Library of Medicine Medical Subject Headings (MeSH) Cosyntropin at the U.S. National Library of Medicine Medical Subject Headings (MeSH)
International Union of Biochemistry and Molecular Biology (IUBMB) An international non-governmental organization devoted to promoting scientific research and education in the disciplines of biochemistry and molecular biology, primarily by standardizing biochemical nomenclature, developing and publishing laboratory methods, and awarding grants and fellowships to students and researchers.
It is a measurement of the contribution of a genotype to the next generation where a value of 1 would be completely selected against and make no contribution and 0 is not selected against at all. This definition of neutral mutation has been criticized due to the fact that very large effective population sizes can make mutations with small selection coefficients appear non neutral. Additionally, mutations with high selection coefficients can appear neutral in very small populations. The testable hypothesis of Kimura and others showed that polymorphism within species are approximately that which would be expected in a neutral evolutionary model. For many molecular biology approaches, as opposed to mathematical genetics, neutral mutations are generally assumed to be those mutations that cause no appreciable effect on gene function. This simplification eliminates the effect of minor allelic differences in fitness and avoids problems when a selection has only a minor effect. Early convincing evidence of this definition of neutral mutation was shown through the lower mutational rates in functionally important parts of genes such as cytochrome c versus less important parts and the functionally interchangeable nature of mammalian cytochrome c in in-vitro studies. Nonfunctional pseudogenes provide more evidence for the role of neutral mutations in evolution. The rates of mutation in mammalian globin pseudogenes has been shown to be much higher than rates in functional genes.
Silver nitrate produces long-lasting stain when applied to skin and is one of indelible ink's ingredients. An electoral stain makes use of this to mark a finger of people who have voted in an election, allowing easy identification to prevent double-voting. In addition to staining skin, silver nitrate has a history of use in stained glass. In the 14th century, artists began using a "silver stain" (also known as a yellow stain) made from silver nitrate to create a yellow effect on clear glass. The stain would produce a stable color that could range from pale lemon to deep orange or gold. Silver stain was often used with glass paint, and was applied to the opposite side of the glass as the paint. It was also used to create a mosaic effect by reducing the number of pieces of glass in a window. Despite the age of the technique, this process of creating stained glass remains almost entirely unchanged.
Most tests will incorporate a second line which contains a further antibody (one which is not specific to the analyte) that binds some of the remaining colored particles which did not bind to the test line. This confirms that fluid has passed successfully from the sample-application pad, past the test line. By giving confirmation that the sample has had a chance to interact with the test line, this increases confidence that a visibly-unchanged test line can be interpreted as a negative result (or that a changed test line can be interpreted as a negative result in a competitive assay).
Sources: en.wikipedia.org
Reversed-phase high-performance liquid chromatography with ultraviolet detection at 214 nanometres is the usual approach. Peak area percentage provides a purity figure relative to other components in the sample. Mass spectrometry is then applied to confirm identity.
Aspartate can cyclise into a succinimide intermediate that later hydrolyses back as isoaspartate. Both forms share the same molecular mass, so mass spectrometry alone cannot tell them apart. This shapes how purity data should be interpreted.
Freeze-dried material is normally kept desiccated below minus twenty degrees Celsius and shielded from light. Solutions are prepared shortly before use and held cold. Repeated thawing is avoided because it accelerates aggregation and degradation.
The peptide contains four residues in the order alanine, glutamate, aspartate and glycine, abbreviated AEDG. The chain is linear and held together by three peptide bonds. Its calculated mass for the uncharged free form is about 390.3 daltons.